Ideal for protection and wood colouration
Protective and decorative exterior woodstain for interiors and exteriors with depth wetting properties.
It colours the wood, enhancing the grain.
It contains UV filters and antiseptic additives that provide effective protection against fungi and insects.
Colours are light resistant and have good resistance to atmospheric agents.
Recommendations for application:
Naturaqua Holz Lasur colours are normally brighter, however solvent-based Holz Lasur is characterised by a better penetration and protection capacity. Apply by brush, spray, dipping.

Universal Stain Concentrate / Interiors and Exteriors A Special water based liquid stain of high strength and light resistance used to colour directly raw wood as well to Tint Basecoats or Topcoats of the NATURAQUA RANGE. Due to its particular formula the stain can be used for Interior as Exterior projects, keeping a good colour brightness till a max suggested dilution ratio 1-1. Ready for use can be diluted with water, alcohol, acetone and other polar solvents, once dry allows to be overcoated with any type of lacquer waterborne, thinner based or PU.

Concentrated universal liquid dye. For indoor wooden surfaces. Dilutable in water, acetone, alcohol and nitro thinner for the preparation of base colors. It is also used in small percentages to tone lacquers. Perfectly replaces powdered anilines.

Waterbased exterior woodstain. It penetrates into the fibers, providing a first protection. Indoor and outdoor use. Complete the working cycle with the desired finish (e.g. Naturaqua Top Gel).

Powder stain, widely used in the traditional restoration. Applied in water dispersion, with different amounts depending on the final intensity of the desired tone, it is suitable for local touch up as well as for the colouring of large areas. Only for indoor use.

A waterbased acrylic, waxy impregnating self-sealing 3-in-1 finish for interiors and exteriors.
Odourless and dilutable in water it enhances the grain of the wood using natural and bright colours for deep penetration of the wood.
Water repellent and breathable it protects the wood from atmospheric agents. Added UV filters impart light-stability and special additives protect the wood against harmful biological agents. Application of two or three coats is recommended. Recommendations for application:
The colours of Naturaqua Holzwachs Lasur 3IN1 are brighter than the same Holzwachs Lasur 3IN1 oil-wax base.
The level of protection offered by the two products is very similar, however the water-based version needs intermediate sanding between the coats and restoration phase.

It is a waterbased vehicle ready to use, with a special aging effect. If applied to tannin-rich woods, such as oak, it easily creates surfaces with an antique appearance. If added with water-based pastes or Waterbased mordant concentrates, they allow to obtain special color effects even on larch. Only for interiors.

Designed to protect wooden structures before final painting as a surface barrier. A waterbased, odourless and quick-drying Primer formulated to protect newly built, wooden structures while waiting for the subsequent finishes. It provides effective protection against mildew, fungi formation and insect infestation, even in the absence of other treatments. It does not change the colour of the wood and allows the subsequent application of any finish. Recommendations for application:
The product can be used as a pre-treatment before exterior woodstain products, lacquers or finishes in general.BR> Thanks to the high content of active ingredients, it is recommended for waterbased finishing cycles to guarantee greater protection and prolong the duration of the coating. For Exterior use.

Water-based dye, ready to use with positive effect (strong highlighting of the wood structure).
It is applied on a rough surface. Special for soft woods, only for interiors.

It's the ideal product for staining any kind of wood exalting its structure. For Indoor use. Ready to use and fast drying. Specially formulated to stain raw barewood or stripped wood during restoration, they are usually applied before the traditional final lacquering, giving a pleasant color tone. Highly shiny, they enhances the woodgrain, penetrating deeply.