Ready-to-use high coverage enamel, easy to apply, suitable for all types of backgrounds, indoors and outdoors. Glossy and opaque.

Creates a decorative film, water repellent and resistant to atmospheric agents, low yellowing. High density, filling and covering capacity, it is recommended for finishing or maintenance of wood, iron and masonry surfaces.

Ready-to-use high coverage enamel, easy to apply, suitable for all types of backgrounds, indoors and outdoors. Glossy and opaque.

Creates a decorative film, water repellent and resistant to atmospheric agents, low yellowing. High density, filling and covering capacity, it is recommended for finishing or maintenance of wood, iron and masonry surfaces.

Ready-to-use high coverage enamel, easy to apply, suitable for all types of backgrounds, indoors and outdoors. Glossy and opaque.

Perfect for any type of surface, whether wood or metal, outside as well as inside.
Designed specifically to perform ideally on vertical surfaces.
No dripping.

Ready-to-use water-based enamel, ecological and odorless, easy to apply, suitable for any type of support, indoors and outdoors.
High density, it is recommended for finishing or maintenance of wood, iron, masonry etc. surfaces.
It does not require a specific primer for wood, but it is possible to consider the use of the Water Undercoat (code NAT6910) or the rustproof Undercoat (code 6915)

Ideal for protection and wood colouration
Protective and decorative exterior woodstain for interiors and exteriors with depth wetting properties.
It colours the wood, enhancing the grain.
It contains UV filters and antiseptic additives that provide effective protection against fungi and insects.
Colours are light resistant and have good resistance to atmospheric agents.
Recommendations for application:
Naturaqua Holz Lasur colours are normally brighter, however solvent-based Holz Lasur is characterised by a better penetration and protection capacity. Apply by brush, spray, dipping.

High coverage Undercoat is a ready-to-use product, easy to apply, recommended for wood, indoors and outdoors. It creates a smoothing and filling layer that facilitates the subsequent application of High Coverage Enamel . Ideal for furniture, paneling, attics, beams, fixtures, fences, wooden houses, boats.

Waterbased exterior woodstain. It penetrates into the fibers, providing a first protection. Indoor and outdoor use. Complete the working cycle with the desired finish (e.g. Naturaqua Top Gel).

Special anchoring undercoat for galvanized sheet metal or difficult metals in general (cast iron, copper, brass, steel) and plastic materials such as PVC. Allows overcoating with any type of enamel.

Recommendations for application:

Suitable for Interiors and Exteriors.

Ready-to-use base, odorless and environmentaL friendly, easy to apply, recommended for wood, indoors and outdoors.
Of high density, it is recommended for finishing or maintenance cycles of wooden surfaces where an effect of considerable coverage and uniformity is desired, granting correct adhesion of the finish. Fluent and elastic, it is characterized by excellent distension and does not drip.

The Antirust Rust Undercoat is a product ready for use, easy to apply, recommended as a primer for iron, indoors and outdoors.

Of high density, it is recommended for finishing or maintenance cycles of iron surfaces, new or already treated.

Ideal for furniture, gates, fixtures, iron cladding in general.