Odourless, light-stable and ecological water-based putty for wood. The white version is also suitable for smoothing plaster. Formulated to minimise shrinkage on drying and to allow colours to be inter-mixable with each other to create limitless shades.

Special putty in powder form with wood flour specific for wooden surfaces, can also be used on wall supports. To be mixed with water, it is ideal for grouting wood imperfections and for reconstructing missing parts. It adheres perfectly to all surfaces. Colors resistant to light. Can be overpainted with PU, acrylic, epoxy, UV and water-based paints.

It is a detergent based on natural soap with a neutral pH, for the cleaning of varnished or oil-treated wooden floors. Pleasantly scented, it removes dirt and grease, without damaging the varnishes, cleaning them effectively but at the same time gently. Suitable for daily cleaning

Mixture of detergent surfactants in water. Highly concentrated, can be diluted up to six times with water (1: 6). Easily removes old wax layers. Sanitize in depth.

It is a waterbased vehicle ready to use, with a special aging effect. If applied to tannin-rich woods, such as oak, it easily creates surfaces with an antique appearance. If added with water-based pastes or Waterbased mordant concentrates, they allow to obtain special color effects even on larch. Only for interiors.

It is a waxy emulsion with no solvents, designed for the protection and renewal of worn-out parquet. Its composition of natural waxes supplemented with surfactants give a pleasant wear-resistant brilliance. Ideal for protecting oil-treated and lacquered floors. Apply evenly without overlapping. Wait for it to dry completely. According to the type of finishing that needs to be revitalized, there is a matt (for 20-40 gloss matt oil/lacquer finishings) and deep matt (for zero gloss, natural effect finishings) versions of the product. Indicative yield: 60-70m2 / Lt

Standard
Cod. 0490-90
Cod. 0491-90

Opaco
Cod. 0490-30
Cod. 0491-30

Opaco profondo
Cod. 0490-10
Cod. 0491-10

It is a waterbased ready to use vehicle, with a special antique effect.
Ideal for oak, it easily creates supports with an antique appearance with particular shades of grey. It is recommended to carry out preliminary tests to verify the final result.

Transparent acrylic lacquer for indoor and outdoor use. It creates an almost invisible film for a rough wood effect. Fields of application: as an insulator to guarantee good adhesion of water-based finishes on oily exotic woods such as teak, iroko and similar; as a surface fixative fornatural effect finishes . Catalyze the product with Borma 4100-2K at 10% to improve its adhesion and surface resistance.

This waterbased product lightens the colour of raw wood and neutralises the effect of the two aging vehicles Holz Antix 2008 and Holz Antix 2010, returning ing the colour back to the original one.
To avoid unwanted effects, we recommend overcoating with products from our Parquet Oil Range and afterwards, if required, apply a waterbased finish.
Recommendations for application:
Apply the product on raw wood or on surfaces that were treated with Holz Antix 2008 or 2010 using synthetic brushes or sponges or, on wide areas, using a spreader.
A preliminary test is always recommended to verify the result.
Suitable also for use on oak wood.
Approx. yield: 20-30 m²/Lt.

Ready-to-use binder resin for the individual preparation of quick drying wood putty.
Mixed with wood dust from the sanding process it enables a filler matching the original Colour of the wood to be obtained.
Any customised colour shades can be achieved with the addition of a few drops of the Borma Holzfarbe Wood Concentrate dyes. Use water for thinning/dilution.